Now go into the Tunnel you created, and click add peer Now head back to the PFSENSE Window with the Tunnel configruation, and add that IPv4 address and subnet mask into the Interface Address, give it a name and hit Save Tunnel That's all, you can close the window now. Substitute the 000's for your account number with no spaces, and paste the public key we generated in PFSENSE earlier. You'll want to paste the below in Notepad and get it set up, then paste into the PFSENSE ShellĬurl -d account=0000000 -data-urlencode pubkey=YOURKEYHERE This isn't really a great idea, and this way is better. You can do this via the browser, but as /u/Griffo_au on reddit pointed out, you need to upload your private key. So if nothing else, just SSH to PFSENSE and follow these steps. I did it on my Mac, but your PFSENSE box also does. Do this from any system that has curl on it. Now we need to upload this key to Mullvad in order to get back the IP addresses we can use. Leave the port as default and click generate under the interface key.Ĭopy this key to a a notepad (Or whatever you like) as we will need it later.

Now in the top bar, go to VPN > Wireguard > Settings and make sure its enabledĬlick to enable the tunnel, enter a name, it can be anything you like. If you don't, just click 'Available Packages' and search for Wireguard, and install it. Go to System > Package Manager and make sure you have Wireguard installed Note that you should keep your account number secret. Save your account number, and pay for the plan.

So I looked over 4 or 5 guides on how to set it up, and wrote this including screenshots, to make it easy.įirst click the above link, or just go to and sign up for an account. I could not find a complete guide on how to get PFSENSE connected to Mullvad with Wireguard. Using WireGuard if PFSENSE I get full line speed with very low CPU Usage on the firewall.

Mullvad openvpn config